Relatively straight forward – just one little oops on DX Engineering’s side of the fence – and a little tedious getting the nylon washers installed – altogether not bad . . .
The instructions did a really good job explaining the assembly – just don’t tell Red that I followed the instructions – my Possum Lodge membership possibly would be in jeopardy – LOL!
Ready to start – Oh Boy! . . .
And the little oopsie – the nut holding the “F” connector / circuit board was not tight . . .
The nuts holding the mounting bracket to the antenna assembly junction box were fine . . .
Snugged it down and put the junction box cover back on – making sure the cover gasket was in place and then on to the finicky nylon shoulder washers – the amplifier box itself must be isolated from the mast bracket since the mast bracket and rotator will be earth grounded . . .
Ready to mount to the rotator/4×4 mast assembly – YAY! . . .
And yes I will check the antenna to make sure it is functioning before I put “It” and the 4×4 up as a finished assembly – just saying . . .
Have Fun! – Run the Gun! – and remember – Fish Heads are Cheap!!
Guns, Fun, Food and More 